Ridge, rake, eave, valley, corner, and base conditions formed from the same coil as the panels, plus custom flashing for anything a standard piece does not cover.
Each piece is bent to match the profile and finish of your panels so the elevation reads as one system. Custom shapes are formed to the condition when a standard piece does not fit.
Ridge Cap
Closes and weatherproofs the ridge where two roof planes meet.
Rake Trim
Finishes and weatherproofs the sloped gable edge of a roof.
Eave Trim
Directs water off the roof edge at the eave and finishes the panel run.
Valley Trim
Channels water where two roof planes intersect at an inside angle.
Corner Trim
Finishes outside and inside wall corners with a clean, weather-tight edge.
Base Trim
Finishes the bottom of wall panels and closes the wall-to-slab joint.
Need Trim to Match a Panel Order?
Send the panel profile, color, and the conditions you need to close. We will confirm the trim pieces, flag anything that needs a custom bend, and get a material list back to you.
Use this A.I. tool to ask about metal roofing panels, panel profiles, steel building supplies, accessories, and how to spec out your project with Frontier Metals.
